HAT520N/530N Dual Power ATS Controller is made by the core of the
microprocessor, which can precisely detect 2-way 3-phase voltages,
2-way single phase voltages and make accurate judgment for the
occurred abnormal voltages (lost of power, over voltage, under
voltage, over frequency, under frequency, loss of phase, phase
sequence wrong), controlling ATS switchover after delay. It is
suitable for controlling No Breaking ATS, and it has the function
of issuing genset start signal after abnormal delay of one way. By
LINK communication port, "three remotes" (remote measurement,
remote communication and remote control) function can be realized.
Performance and Characteristics
It has the following characteristics:
— Measure and display 2-way 3-phase Voltage and Frequency:
1# Line
voltage (Uab, Ubc, Uca)
Phase voltage (Ua, Ub, Uc)
Frequency Hz
2#Line
voltage (Uab, Ubc, Uca)
Phase voltage (Ua, Ub, Uc)
Frequency Hz
— Over/under voltage, loss of phase, phase sequence wrong,
over/under frequency protection function.
As default, phase sequence wrong protection and over/under
frequency protection are disabled;however, users can set the
protection function as you need.
— LINK communication port (SmartGen SG72 adapter is needed), with
which controller parameters can
be set and firmware update also can be realized. — The voltage
normal delay of 1# or 2# can be set (Range: 0s~60s) and Genset
start delay can be set(Range: 0s~3600s).
— The voltage abnormal delay of 1# or 2# can be set (Range: 0s~60s)
and Genset stop delay can be set (Range: 0s~3600s).
— “1# Master”, “Each Backup” and “2# Master” can be set via
controller front panel, so that 1# power master supply, or 2# power
master supply, or mutual backup power supply for each other can
berealized.
— Close output signal can be set as pulse or continuous output.
— 2-way N-wire isolated design.
— Auto/Manual mode transfer. In manual mode, ATS transfer 1# switch
or 2# switch can be implemented via panel pushbutton.
— LEDs mounted on front panel can clearly show ATS running status.
— The output contactor capacity of 1# and 2# power transfer relay
(1# CLOSE, 2# CLOSE) is 16A AC250V, volts-free contact, which can
be directly used in driving switch to transfer.
— The output contactor capacity of Genset start relay (GENS START)
is 7A AC250V/7A DC28V,volts-free N/C contact.
— Suitable for various AC systems (3-phase 4-wire, 2-phase 3-wire
and single-phase 2-wire).
— Modular design, flame retardant ABS plastic shell, pluggable
terminal, built-in mounting, compact structure with easy
installation.
